Embark on an odyssey where every challenge is an invitation to learn, made effortless with the 350-801 dumps. Journeying through this realm, the 350-801 dumps illuminate your path with golden nuggets of practice questions. PDFs are the age-old manuscripts, repositories of wisdom, while the VCE format is the bard, singing tales of interactive learning. Together, the study guide and 350-801 dumps sketch the roadmap for your expedition. Such is our belief in this voyage that we present our 100% Pass Guarantee, a promise of safe passage in your quest for knowledge.
[Fresh Launch] Gear up for an exam win with the gratis 350-801 PDF and Exam Questions, vowing for 100% achievement
Question 1:
A collaboration engineer must optimize the dial plan within Cisco UCM. There are multiple remote sites. And each site has its own route patterns and local gateways. What should the engineer do on the cisco UCM to optimize the dial plan?
A. Configure a Standard Local Route Group to use a single route pattern for all calls within the cluster.
B. Create a centralized dial plan with a Cisco UCM Session Management Edition cluster or a Cisco gatekeeper.
C. Implement ILS with GDPR so the dial plan can dynamically replicate across clusters.
D. Leverage Cisco UCM Express as SRST so the phones can have more features of each remote site
Correct Answer: A
Question 2:
Refer to the exhibit.
The translation rule is configured on the voice gateway to translate DNIS. What is the outcome if the gateway receives 0255-343-1234 as DNIS?
A. The translation is not matched because DNIS contains “-“.
B. The translation is not matched because DNIS does not end with a “$”.
C. The translation is matched and the translated number is 02553431234.
D. The translation is matched and the translated number is 025553431234.
Correct Answer: C
Question 3:
Where would an administrator update learned patterns from the DNA UI?
A. System –> Enterprise parameters
B. Service –> Control Center –> DNA
C. Service –> Control Center
D. System –> Service Parameters
Correct Answer: C
Question 4:
An administrator is configuring a new Cisco UCM with PSTN capabilities. Due to bandwidth constraints, audio compression is used on the codec. DTMF must work as expected because the customer is calling many call centers where the users must select options in the call. Where is DTMF out-of-band in a CCM 12.5 with SIP-based gateway configured?
A. in the DTMF setting under SIP profile on the Cisco Unified Border Element
B. in DTMF settings in the audio codec preference list under regions in the Cisco UCM
C. in regions on the Cisco UCM where you set the appropriate codec to use
D. in the dial peer on the Cisco IOS router
Correct Answer: D
Reference: https://www.cisco.com/c/en/us/support/docs/unified-communications/unified-border-element/200412-DTMF-Relay-and-Interworking-on-CUBE.html
Question 5:
Which characteristic of distributed class-based weighted fair queueing addresses jitter prevention?
A. It provides additional granularity by allowing a user to create classes.
B. It uses a priority queue for voice traffic to avoid jitter.
C. It minimizes jitter by implementing a priority queue for voice traffic.
D. It provides additional granularity by allowing a user to define custom classes.
Correct Answer: C
Question 6:
Which description of the Mobile and Remote Access feature is true?
A. Collaboration Edge feature that enables remote individuals to perform international calls from Jabber with a VPN connection.
B. Collaboration Edge feature that enables remote individuals to access all enterprise collaboration services using a PC within the corporate environment.
C. Collaboration Edge feature that enables remote individuals to access enterprise collaboration services via Jabber without the use of a VPN connection.
D. Collaboration Edge feature that enables remote individuals to access enterprise collaboration services via Jabber with the use of a VPN connection.
Correct Answer: C
Question 7:
There is a saturated link that has traffic shaping configured. How is incoming traffic processed?
A. Excess traffic is queued for later transmission.
B. Excess traffic is dropped.
C. Traffic is compressed so that the traffic fits within the bandwidth of the link.
D. Excess traffic is queued, and then dropped after the timer expires.
Correct Answer: A
Question 8:
An engineer with ID378163512 is designing a new dial plan for a customer that has offices in several countries on four continents around the world. This client also want to integrate with a Microsoft Lync backend, which dial plan type does the engineer recommend?
A. SIP URI
B. TEHQ
C. H.323
D. E.164
Correct Answer: D
E164 is the international numbering plan meant to ensure each number is globally unique.
Question 9:
Which design restriction applies to Cisco Unified Communications Manager Session Management Edition clustering over the WAN deployment with extended round-trip times in Cisco Unified CM 9.1 and later releases?
A. SIP and H.323 intercluster trunks are supported.
B. Only SIP trunk is supported.
C. SIP trunks and H.323 gateways are supported.
D. A minimum of 1.544 Mb/s bandwidth is required for all traffic between any two nodes in the cluster.
E. Only RSVP agents can be configured and registered to the SME cluster as media resources.
Correct Answer: B
Question 10:
Which configuration concept allows for high-availability on IM and Presence services in a UC environment?
A. IM and Presence subclusters (configured on Cisco UCM)
B. Presence Redundancy Groups (configured on Cisco Unified IM and Presence)
C. IM and Presence subclusters (configured on Cisco Unified IM and Presence)
D. Presence Redundancy Groups (configured on Cisco UCM)
Correct Answer: D
Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/12_0_1/systemConfig/cucm_b_system-configuration-guide-1201/cucm_b_system-configuration-guide-1201_chapter_0110010.html
Question 11:
What are two reasons that AF41 is marked for the audio and video channels of a video call? (Choose two.)
A. to allow high-definition quality calls over low-speed links
B. to give video calls a higher priority than AF41 in the QoS policy
C. to provide separate classes for audio calls and video calls
D. to preserve lip synchronization between the audio and video channels
E. to prioritize video over other high-priority traffic classes
Correct Answer: CD
Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/srnd/collab10/collab10/netstruc.html
Question 12:
Which two devices are supported by the Flexible DSCP Marking and Video Promotion feature? (Choose two.)
A. MGCP devices
B. SCCP devices
C. pass-through MTPs
D. H.323 trunks
E. DX80
Correct Answer: BC
Question 13:
Which two types of device are supported by the Bulk Administration Tool? (Choose two.)
A. H.322 clients
B. Cisco Unified IP phones (all models)
C. SIP trunks
D. H.225 trunks
E. music on hold servers
Correct Answer: AB
Question 14:
Refer to the exhibit. In this cisco UCM setup configured for EARLY offer, what is the codec preference line in the initial SIP INVITE SDP?
A. m=audio 16444 RTP/AVP 9 18 101
B. m=audio 16444 RTP/AVP 0 8 18 101
C. m=audio 16444 RTP/AVP 18 101
D. m=audio 16444 RTP/AVP 9 0 8 18 101
Correct Answer: C
Question 15:
Which Webex Calling construct is used to organize calling features within a physical site?
A. client settings
B. locations
C. service settings
D. call routing
Correct Answer: B
A location is a physical site that contains users, devices, and resources. Locations are used to organize calling features within a physical site. For example, you can create a location for each of your offices and then assign users, devices, and resources to that location. This will allow you to manage calling features for each office separately.